If you have been reading about electrospray ionization and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-01-11. Where a claim depends on a specific study, the study is described rather than over-claimed.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Reversed-phase HPLC retention time versus reference standard | Retention depends on column, gradient, and ion-pairing agent |
| Mass confirmation | Electrospray or MALDI mass spectrometry | Doubly protonated ion near m/z 377 is consistent with about 752 Da |
| Typical purity specification | 95 percent or higher by chromatographic peak area | Lower values suggest truncated or modified peptide species |
| Storage of lyophilized powder | -20 °C, desiccated, protected from light | Powder tolerates long storage better than solution |
| Storage of solution | 2-8 °C for short periods | Freeze-thaw cycling promotes aggregation and surface adsorption |
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Reverse-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres is the standard purity method. Mass spectrometry, typically electrospray ionisation, confirms identity through the expected mass-to-charge pattern. Amino acid analysis can verify composition independently. Chiral purity requires separate techniques such as derivatisation followed by chromatographic separation, and such data are rarely reported for research-grade material.
Quantification in biological matrices relies on liquid chromatography coupled to tandem mass spectrometry with stable-isotope internal standards. Low plasma concentrations and adsorption to container surfaces both complicate measurement. Solid-phase extraction is often needed to reduce matrix interference before injection. Reported limits of quantification differ widely between laboratories, which makes direct comparison of pharmacokinetic results difficult and limits meta-analysis.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Characterization of Selank in laboratory settings relies on standard peptide analytical techniques. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities and degradation products, while mass spectrometry confirms molecular identity through accurate mass measurement. Amino acid analysis and peptide sequencing verify the primary structure when reference material is unavailable. Because Selank is a short chain, fragmentation-based analysis produces a diagnostic ion pattern that supports confident identification.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Quality assessment of Selank samples typically combines purity determination with identity confirmation and counter-ion analysis. Purity is usually reported as a percentage by chromatographic area, with values above 95 percent often quoted for research-grade material. Water content and residual solvents are checked in lyophilized batches because they affect both stability and accurate mass determination. A reported purity figure does not by itself establish that a sample is the intended sequence, so orthogonal methods are needed to rule out sequence isomers or truncation products.
His explorations on Pichincha included documenting frequent earthquakes, which led to local rumors attributing the tremors to his presence. Humboldt’s work during this period advanced scientific understanding of high-altitude geology and volcanology.
First, the species is compatible with the main wine yeast Saccharomyces cerevisiae, though in cases where both MLF and alcoholic fermentation are started together, the yeast most often outcompetes the bacterium for nutritional resources which may cause a delay in the onset of malolactic fermentation. Second, most strains of O. oeni are tolerant to the low pH levels of wine and can usually deal with the standard alcohol levels that most wines reach by the end of fermentation. Additionally, while sulfur dioxide levels above 0.8 molecular SO2 (pH dependent but roughly 35-50 ppm) will inhibit the bacteria, O. oeni is relatively resistant compared to other LAB. Finally, O. oeni tends to produce the least amount of biogenic amines (and most lactic acid) among the lactic acid bacteria encountered in winemaking.
=== Cytoskeleton associated functions === CK1δ is involved in the regulation of microtubule polymerization and stability of the spindle apparatus and centrosomes during mitosis by directly phosphorylating α-, β-, and γ-tubulin. Additionally, CK1δ can also phosphorylate microtubule-associated proteins (MAPs) thereby influencing their interaction with microtubules as well as microtubule dynamics.
Sources: en.wikipedia.org
== External links == Fisher HealthCare Clinical Catalog - The Digital Edition Fisher HealthCare Rapid Diagnostics Catalog - The Digital Edition 1980 article on Fisher's product line ISO 9001:2015 Quality System Certified Organization, Scientific Lab Equipment 1987 article on Fisher products
Esters can be directly converted to nitriles. Methyl esters are often susceptible to decarboxylation in the Krapcho decarboxylation. Phenyl esters react to hydroxyarylketones in the Fries rearrangement. Specific esters are functionalized with an α-hydroxyl group in the Chan rearrangement. Esters with β-hydrogen atoms can be converted to alkenes in ester pyrolysis. Pairs of esters are coupled to give α-hydroxyketones in the acyloin condensation.
=== Components === Cells: Chondrocytes are an obvious choice to use in the regeneration of cartilage due to their ability to secrete collagen and other ECM components necessary for the functional properties of cartilage. Chondrocytes can be harvested from a non-weight bearing joint space of an individual and cultured. Unfortunately, chondrocytes harvested from individuals may dedifferentiate and lose their properties. Additionally, aging chondrocytes show less metabolic activity and may not produce functional proteins or not enough functional proteins to create a desired ECM. Mesenchymal stem cells can also be used to create chondrocytes and make cartilage regeneration possible. Growth factors: Growth factors can be used to induce differentiation of a cell or induce secretion of matrix proteins. Common growth factors for the application of synthetic cartilage include Insulin-growth factor 1 (IGF-1), Transforming Growth Factor β (TGF- β), Bone Morphogenic Proteins (BMP) and Growth and Differentiation Factor 5 (GDF-5). Human induced pluripotent stem cells (iPSCs) are an alternative cell source that have the potential to self-renew and provide an almost unlimited number of cells with pluripotent capabilities, or the ability to differentiate into many different cell types. Bioinks: these are the materials used to engineer artificial live tissue using 3D printing technology. Bioinks can be composed solely of cells, but are usually a combination of cells and a carrier material, often a biopolymer gel.
Langer's lines, Langer lines of skin tension, or sometimes called cleavage lines, are topological skin lines drawn on a map of the human body. They are parallel to the natural orientation of collagen fibers in the dermis, and generally parallel to the underlying muscle fibers. Langer's lines have relevance to forensic science and the development of surgical techniques.
Sources: en.wikipedia.org
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.
Lyophilized powder is normally stored desiccated at -20 °C, protected from light and moisture. Powder kept under these conditions is generally stable for long periods. Solutions are less stable and are usually prepared immediately before use.
A purity value from one chromatographic method does not capture every possible impurity. Related peptides with similar retention behavior, counterions, and residual solvents may not appear in the same analysis. Independent testing with an orthogonal method provides stronger assurance of identity and content.
Selank is a seven-amino-acid peptide built from the tuftsin sequence plus a Pro-Gly-Pro tail. It is produced by chemical synthesis rather than extracted from a natural source. The free peptide is usually supplied as a lyophilised powder or in an aqueous formulation.