reverse-phase HPLC raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2025-09-15 and is reviewed periodically as new material appears.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
| Property | Value | Notes |
|---|---|---|
| Dry storage temperature | -20 C or below | Sealed, desiccated, protected from light |
| Solution stability | Hours to days at 2-8 C | Depends on buffer and microbial load |
| Preferred pH range | Near neutral to slightly acidic | Alkaline pH accelerates hydrolysis |
| Main degradation routes | Hydrolysis and deamidation | No cysteine or methionine in sequence |
| Identity confirmation | Electrospray mass spectrometry | Observed mass compared with 751.9 Da |
Selank is a synthetic heptapeptide developed in Russia as a structural analogue of tuftsin, a naturally occurring immunomodulatory tetrapeptide. Its sequence, Thr-Lys-Pro-Arg-Pro-Gly-Pro, keeps the tuftsin core at the N-terminus and appends a Pro-Gly-Pro tail. Researchers at the Institute of Molecular Genetics in Moscow synthesized the compound during the 1990s while searching for peptides with combined anxiolytic and immunomodulatory activity. The added tail was intended to resist enzymatic cleavage and prolong the molecule's presence in circulation.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Proposed mechanisms centre on the GABAergic system. Animal and tissue studies report changes in GABA-A receptor expression and reduced activity of GABA transaminase, the enzyme that degrades GABA. Effects on monoamine turnover, including serotonin and dopamine pathways, are also described, and a separate line of work links the peptide to increased expression of brain-derived neurotrophic factor in hippocampal tissue. Most of these findings come from rodent models and cell preparations. How the individual observations combine into a single coherent mode of action is not settled.
Pharmacokinetic data are sparse and largely derived from animal work. After intranasal administration the peptide appears in plasma within minutes, and reported half-lives are short, on the order of minutes to tens of minutes. Degradation proceeds through ordinary proteolytic cleavage into constituent amino acids and smaller fragments. Direct evidence that intact Selank reaches brain tissue in meaningful amounts is limited, and the extent of blood-brain barrier penetration is debated. Some authors argue that fragments, not the parent peptide, carry much of the observed activity.
=== North America === Accium BioSciences at Swedish Medical Center Cherry Hill, Seattle, WA André E. Lalonde Accelerator Mass Spectrometry Laboratory (AEL AMS) at the University of Ottawa in Ottawa, Canada Beta Analytic Accelerator Mass Spectrometry Facility in Miami, Florida Center for Accelerator Mass Spectrometry (CAMS) at the Lawrence Livermore National Laboratory Center for Applied Isotope Studies (CAIS) at University of Georgia. DirectAMS (D-AMS) radiocarbon labs in Bothell, WA & Seattle, WA Facility for Rare Isotope Beams, Michigan State University, East Lansing, Michigan Institute for Structure and Nuclear Astrophysics, The University of Notre Dame, Notre Dame, Indiana Institute of Energy and the Environment Radiocarbon Laboratory at the Pennsylvania State University, University Park, Pennsylvania MegaSIMS at the University of California, Los Angeles in Los Angeles, CA National Ocean Sciences Accelerator Mass Spectrometry (NOSAMS) Facility at Woods Hole Oceanographic Institution NSF - Arizona Accelerator Mass Spectrometry (AMS) Laboratory Pharmaron ABS, Inc. in Germantown, Maryland Purdue Rare Isotope Measurement Laboratory at Purdue University in West Lafayette, Indiana Trace Element Accelerator Mass Spectrometer (TEAMS) at the Naval Research Laboratory in Washington, DC W.M. Keck Carbon Cycle Accelerator Mass Spectrometry (KCCAMS) Facility at the University of California, Irvine
The period in the late 1970s and early 1980s showed an intensive reawakening of Cold War tensions and conflicts. Tensions greatly increased between the major powers with both sides becoming more militant. Diggins says, "Reagan went all out to fight the second cold war, by supporting counterinsurgencies in the third world." Cox says, "The intensity of this 'second' Cold War was as great as its duration was short."
Controlled-rate and slow freezing, also known as slow programmable freezing (SPF), is a technique where cells are cooled to around -196 °C over the course of several hours. Slow programmable freezing was developed during the early 1970s, and eventually resulted in the first human frozen embryo birth in 1984. Since then, machines that freeze biological samples using programmable sequences, or controlled rates, have been used for human, animal, and cell biology—"freezing down" a sample to better preserve it for eventual thawing, before it is frozen, or cryopreserved, in liquid nitrogen. Such machines are used for freezing oocytes, skin, blood products, embryos, sperm, stem cells, and general tissue preservation in hospitals, veterinary practices and research laboratories around the world. As an example, the number of live births from frozen embryos 'slow frozen' is estimated at some 300,000 to 400,000 or 20% of the estimated 3 million in vitro fertilization (IVF) births. Lethal intracellular freezing can be avoided if cooling is slow enough to permit sufficient water to leave the cell during progressive freezing of the extracellular fluid. To minimize the growth of extracellular ice crystals and recrystallization, biomaterials such as alginates, polyvinyl alcohol or chitosan can be used to impede ice crystal growth along with traditional small molecule cryoprotectants.
Sources: en.wikipedia.org
Skin pack, or skin packaging, is a type of carded packaging where a product (or products) is placed on a piece of paperboard or in trays, and a thin sheet of transparent plastic is placed over the product and paperboard or trays. The printed paperboard/tray usually has a heat-seal coating. The plastic film (LDPE, ionomer, etc.) is softened by heat and draped over the product on the card/tray. Vacuum is used to assist a firm fit. The film bonds to the heat-seal coating on the paperboard. The substrate can be either made specifically for skin packaging, or converted from other paper stock, such as corrugated board. The specially made sheets Solid Bleached Sulfate (SBS) are porous, and allow the vacuum to flow directly through the paper. Most other stocks need to have the sheet perforated with pinholes to allow airflow. The skin-packed piece may then need to be cut into individual units. Cuts such as keyslots, round corners and internal die cuts may be added during the cutting process once the skin pack is secured tightly. Self-adhesive film with an uncoated card is also sometimes used. Skin packaging somewhat resembles a blister pack, with the major difference being that the plastic surrounding the product is formed over the product instead of being pre-formed. Types of plastic film:
== Evolution == It is believed that moonlighting proteins came about by means of evolution through which uni-functional proteins gained the ability to perform multiple functions. With alterations, much of the protein's unused space can provide new functions. Many moonlighting proteins are the result of the gene fusion of two single function genes. Alternatively a single gene can acquire a second function since the active site of the encoded protein typically is small compared to the overall size of the protein leaving considerable room to accommodate a second functional site. In yet a third alternative, the same active site can acquire a second function through mutations of the active site. The development of moonlighting proteins may be evolutionarily favorable to the organism since a single protein can do the job of multiple proteins conserving amino acids and energy required to synthesize these proteins. However, there is no universally agreed upon theory that explains why proteins with multiple roles evolved. While using one protein to perform multiple roles seems advantageous because it keeps the genome small, we can conclude that this is probably not the reason for moonlighting because of the large amount of noncoding DNA.
Wnt signaling has been implicated in the development of other cancers as well as in desmoid fibromatosis. Changes in CTNNB1 expression, which is the gene that encodes β-catenin, can be measured in breast, colorectal, melanoma, prostate, lung, and other cancers. Increased expression of Wnt ligand-proteins such as Wnt1, Wnt2 and Wnt7A were observed in the development of glioblastoma, oesophageal cancer and ovarian cancer respectively. Other proteins that cause multiple cancer types in the absence of proper functioning include ROR1, ROR2, SFRP4, Wnt5A, WIF1 and those of the TCF/LEF family. Wnt signaling is further implicated in the pathogenesis of bone metastasis from breast and prostate cancer with studies suggesting discrete on and off states. Wnt is down-regulated during the dormancy stage by autocrine DKK1 to avoid immune surveillance, as well as during the dissemination stages by intracellular Dact1. Meanwhile Wnt is activated during the early outgrowth phase by E-selectin. The link between PGE2 and Wnt suggests that a chronic inflammation-related increase of PGE2 may lead to activation of the Wnt pathway in different tissues, resulting in carcinogenesis.
Sources: en.wikipedia.org
Dry powder is best kept sealed, protected from light, and held at minus 20 degrees Celsius or below. Desiccant packaging helps limit moisture uptake because the material is hygroscopic. A sealed vial should be allowed to equilibrate to room temperature before opening to reduce condensation.
Hydrolysis of peptide bonds and deamidation of arginine and proline residues are the main degradation routes. Alkaline pH and higher temperatures accelerate both processes. Buffered, near-neutral solutions stored cold generally degrade more slowly than unbuffered ones.
Reverse-phase chromatography gives the clearest single view of related impurities and truncated sequences. Mass spectrometry then confirms that the main peak carries the expected mass. Neither test detects enantiomeric impurities, which require a separate chiral assay.
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.