This is a working overview of certificate of analysis, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-03-09. Anything still debated is marked as such rather than presented as settled.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by RP-HPLC | Area percentage of the main peak |
| Identity confirmation | Electrospray ionization mass spectrometry | Observed mass compared with the theoretical value near 751.9 Da |
| Recommended dry storage | -20 °C, desiccated | -80 °C for multi-year archival material |
| Solution handling | Prepare fresh; avoid long storage | Sterile filtration reduces microbial load |
| Common synonyms | TKPRPGP; TP-7 | Sequence code and laboratory designation used interchangeably |
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
=== Graphene === Layering graphene on top of gold has been shown to improve SPR sensor performance. Its high electrical conductivity increases the sensitivity of detection. The large surface area of graphene also facilitates the immobilization of biomolecules while its low refractive index minimizes its interference. Enhancing SPR sensitivity by incorporating graphene with other materials expands the potential of SPR sensors, making them practical in a broader range of applications. For instance, the enhanced sensitivity of graphene can be used in conjunction with a silver SPR sensor, providing a cost-effective alternative for measuring glucose levels in urine. Graphene has also been shown to improve the resistance of SPR sensors to high-temperature annealing up to 500 °C.
=== EC 1.4.3 With oxygen as acceptor === EC 1.4.3.1: D-aspartate oxidase EC 1.4.3.2: L-amino-acid oxidase EC 1.4.3.3: D-amino-acid oxidase EC 1.4.3.4: monoamine oxidase EC 1.4.3.5: pyridoxal 5′-phosphate synthase EC 1.4.3.6: replaced by two enzymes, EC 1.4.3.21 (primary-amine oxidase) and EC 1.4.3.22 (diamine oxidase) EC 1.4.3.7: D-glutamate oxidase EC 1.4.3.8: ethanolamine oxidase EC 1.4.3.9: Now included with EC 1.4.3.4 amine oxidase (flavin-containing) EC 1.4.3.10: putrescine oxidase EC 1.4.3.11: L-glutamate oxidase EC 1.4.3.12: cyclohexylamine oxidase EC 1.4.3.13: protein-lysine 6-oxidase EC 1.4.3.14: L-lysine oxidase EC 1.4.3.15: D-glutamate(D-aspartate) oxidase EC 1.4.3.16: L-aspartate oxidase EC 1.4.3.17: Now EC 1.3.3.10, tryptophan α,β-oxidase EC 1.4.3.18: Not approved as the enzyme was shown to be a dehydrogenase and not an oxidase (see EC 1.5.99.12, cytokinin dehydrogenase) EC 1.4.3.19: glycine oxidase EC 1.4.3.20: L-lysine 6-oxidase EC 1.4.3.21: primary-amine oxidase EC 1.4.3.22: diamine oxidase EC 1.4.3.23: 7-chloro-L-tryptophan oxidase EC 1.4.3.24: Now EC 1.4.2.3, pseudooxynicotine oxidase EC 1.4.3.25: L-arginine oxidase EC 1.4.3.26: pre-mycofactocin synthase
The reduced sensations can lead to injuries for either partner and their absence can make it impossible to have sexual pleasure through stimulation of the penis. Since the problems are caused by permanent nerve damage, preventive treatment through good control of the diabetes is the primary treatment. Some limited recovery may be possible through improved diabetes control. Erectile dysfunction is the inability to develop and maintain an erection sufficiently firm for satisfactory sexual performance. Diabetes is a leading cause, as is natural aging. A variety of treatments exist, most notably including the phosphodiesterase type 5 inhibitor drugs (such as sildenafil citrate, marketed as Viagra), which work by vasodilation. Priapism, a form of persistent genital arousal disorder, is a painful and potentially harmful medical condition in which the erect penis does not return to its flaccid state. Priapism lasting over four hours is a medical emergency. The causative mechanisms are poorly understood but involve complex neurological and vascular factors. Potential complications include ischaemia, thrombosis, and impotence. In serious cases the condition may result in gangrene, which may result in amputation. However, that is usually only the case if the organ is broke out and injured because of it. The condition has been associated with a variety of drugs including prostaglandin. Contrary to common knowledge, sildenafil (Viagra) will not cause it. Lymphangiosclerosis is a hardened lymph vessel, although it can feel like a hardened, almost calcified or fibrous, vein.
== External links == hepcidin at the U.S. National Library of Medicine Medical Subject Headings (MeSH) Intrinsic LifeSciences - Hepcidin Research Facility, The BioIron Company Hepcidinanalysis.com - Service for Hepcidin measurements: Scientific Research, Patients and Clinical Trials Protein Data Bank Page PDBe-KB provides an overview of all the structure information available in the PDB for Human Hepcidin
Sources: en.wikipedia.org
The first two bus operating contracts for the new Weaver Network were awarded in September 2026 to FirstGroup, covering Huddersfield and parts of Leeds, and Transdev Blazefield, covering Dewsbury. In October 2021, £830 million of funding was announced for the West Yorkshire Combined Authority through the City Region Sustainable Transport Settlement, including funding to develop mass transit proposals for the region. Consultation was undertaken between July and September 2024 on proposed tram routes linking Bradford and Leeds, and St. James Hospital, central Leeds and White Rose Shopping Centre. Following a review by the National Infrastructure and Service Transformation Authority, the programme was moved to a more sequential approach intended to reduce delivery risk, contributing to a delay in the expected timetable for the scheme.
Protein DAMPs include intracellular proteins, such as heat-shock proteins or HMGB1, and materials derived from the extracellular matrix that are generated following tissue injury, such as hyaluronan fragments. Non-protein DAMPs include ATP, uric acid, heparin sulfate and DNA.
==== Body fluids ==== Cocaine and its major metabolites may be quantified in blood, plasma, or urine to monitor for use, confirm a diagnosis of poisoning, or assist in the forensic investigation of a traffic or other criminal violation or sudden death. Most commercial cocaine immunoassay screening tests cross-react appreciably with the major cocaine metabolites, but chromatographic techniques can easily distinguish and separately measure each of these substances. When interpreting the results of a test, it is important to consider the cocaine usage history of the individual, since a chronic user can develop tolerance to doses that would incapacitate a cocaine-naive individual, and the chronic user often has high baseline values of the metabolites in his system. Cautious interpretation of testing results may allow a distinction between passive or active usage, and between smoking versus other routes of administration.
Sources: en.wikipedia.org
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.
A reported purity value reflects the share of the main peak in one chromatographic run and says nothing about identity. Confirming that the expected sequence is present requires a separate measurement such as mass spectrometry. Purity and identity are distinct questions.
A mass spectrum reports the molecular masses present in a sample and shows whether they match the value expected for selank, near 751.9 Da. It also flags common artifacts such as truncation or adduct formation. It does not establish correct stereochemistry or complete sequence order on its own.
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.